Rebel Droids.net

Looking pretty good!

Update on the build! I printed both hands and shoulder joints, lower legs and feet. I had to stop because I have one roll left and I have a commissioned piece I had to start.

I'm normally wrong...
But the image doesn't appear to be 1:1.
Can you put a tape against the leg?

1040mm tall to the top of his dome
1260mm including the antenna
755mm to the centre of the shoulder joint
490mm to the centre of the hip joint.
These are the demensions I used how could you tell if it is or isn't to scale nothing for reference. Sorry I just don't like critics that haven't contributed

I suspect Alan's curious because I believe he has a build. I think there is a little information on scale, though I don't know personally, but Alan or Savage may be able to help with references.

Dunno if these might be interesting:
http://starwarsscreencaps.com/star-wars-...e-1999/37/
Nose of the podracer is a little lower than waist high? And the pit droids are about that tall a tiny bit later?

That's about right according to references

So I finished my bb8 for the most part, just some fine tuning needed. And now to move on to other projects. Pit droid being one. Half the Dome finished this morning. I cut the lens out of a chrome Christmas ball.

[Image: 83302da04c0eaf1098da0713a2a30052.jpg]