I've updated my laser cut version of Savage's plans:
Changes:
- Added "short" version (renamed old version "tall") in case you want the base to stop at the sloped part.
- Adjusted diameter of top flat disc to better match Kresty's top 3D printed ridge.
- Thickened supports B in back.
- Corrected sizes of diffuser cut templates.
- Created a special J top ring for the grill providing more surface to glue the K ring to.
V3 version of Kresty's laser cut flat pack... Several changes:
- Got rid of the optional taller/lower version. C Band and D Ring are removed for the pointy bottomed (more screen accurate) version.
- That means fewer sheets! All the 1.5mm (3/16") parts are on one sheet.
- Added tabs/slots for the window panel/translucent panel/M ring (removing the notches, which was hard)
- Added mount holes on the M ring for the T hose fittings. (I didn't do the same on the lower parts because I'm not sure the bottom bands can always be aligned well).
- Centered the K-ring tabs, which had been a little off.
- Included the part alignment guide templates.
- Added "alt lower diffuser" - instead of 2 parts it's only one part that's a bit short, however the gap can be positioned at one of the opaque walls of the grill.
![[Image: thumb_Laser_24x18_Alternate_Flat_Pack.png]](http://www.rebeldroids.net/gallery/albums/userpics/10017/thumb_Laser_24x18_Alternate_Flat_Pack.png)